NASA’s Space Shuttle Discovery arrived at its launch pad completing the next major milestone for Return to Flight of America’s Space Shuttle program. The Shuttle arrived at its launch pad at 12:30 a.m. This was approximately three hours later than its scheduled arrival.
The slight delay was caused when Shuttle processing team members had to replace a Programmable Logic Controller (PLC) circuit card on the Crawler Transporter during the final leg of its journey. The Crawler Transporter is the vehicle which transports the Space Shuttle and its Mobile Launcher Platform to the launch pad. The PLC is an indicator that relays height measurements to the Crawler’s operators while it’s in motion.
The issue occurred during Discovery’s initial attempt to climb the incline ramp leading to Pad 39B. When observed, technicians decided to stop the rollout and then reverse Discovery back down the incline ramp to level ground to test and then replace the circuit card. Once the new card was in place, the Crawler functioned normally and the rollout was completed. The Space Shuttle remained level and in a safe configuration throughout all movements and during the changeout of the card.
Once in place at the launch pad, the shuttle team continued preparation of Discovery for its scheduled launch set for a window of May 15 to June 3.
Original Source: NASA News Release
Through the Artemis Program, NASA will send the first astronauts to the Moon since the…
New research suggests that our best hopes for finding existing life on Mars isn’t on…
Entanglement is perhaps one of the most confusing aspects of quantum mechanics. On its surface,…
Neutrinos are tricky little blighters that are hard to observe. The IceCube Neutrino Observatory in…
A team of astronomers have detected a surprisingly fast and bright burst of energy from…
Meet the brown dwarf: bigger than a planet, and smaller than a star. A category…