Astronomy Without A Telescope – Space Towers

[/caption]

Arthur C Clarke allegedly said that the space elevator would be built fifty years after people stopped laughing. The first space tower though… well, that might need a hundred years. The idea of raising a structure from the ground up to 100 kilometers in height seems more than a bit implausible by today’s engineering standards, given that we are yet to build anything that is more than one kilometer in height. The idea that we could build something up to geosynchronous orbit at 36,000 kilometers in height is just plain LOL… isn’t it?

Space tower proponents point to a key problem with the space elevator design. It may only be after we have spent years inventing a method to manufacture 36,000 kilometers of flawless carbon or boron nanotube fiber – which is light enough not to break under its own weight, but still strong enough to lift an elevator cabin – that we suddenly realize that we still have to get power to the cabin’s lifting engine. And doesn’t that just mean adding 36,000 kilometers of conventional (and heavy) electrical cable to the construction?

Mind you, building a space tower brings its own challenges. It’s estimated that a steel tower, containing an elevator and cabling, of 100 kilometers height needs a cross-sectional base that is a 100 times greater than its apex and a mass that is 135 times greater than its payload (which might be a viewing platform for tourists).

A solid construction capable of holding up a launch platform at 36,000 kilometers altitude might need a tower with ten million times the mass of its payload – with a cross-sectional base covering the area of, say, Spain. And the only construction material likely to withstand the stresses involved would be industrial diamond.

A more economical approach, though no less ambitious or LOL-inducing, are centrifugal and kinetic towers. These are structures that can potentially exceed a height of 100 kilometers, support an appreciable mass at their apex and still maintain structural stability – by virtue of a rapidly rotating loop of cable which not only supports its own weight, but generates lift through centrifugal force. The rotation of the cable loop is driven by a ground-based engine, which can also drive a separate elevator cable to lift courageous tourists. Gaining altitudes of 36,000 kilometers is suggested to be achievable by staged constructions and lighter materials. But, it might be sensible to first see if this grand design on paper can translate to a proposed four kilometer test tower – and then take it from there.

There are also inflatable space towers, proposed to be capable of achieving heights of 3 kilometers with hot air, 30 kilometers with helium or even 100 kilometers with hydrogen (oh, the humanity). Allegedly, a 36,000 kilometer tower might be achievable if filled with electron gas. This is a curious substance argued to be capable of exerting different inflationary pressures depending on the charge applied to the thin-film membrane which contains it. This would allow a structure to withstand differential stresses – where, in a highly charged state, the highly excited electron gas mimics a molecular gas under high pressure, but with a reduced charge it exerts less pressure and the structure containing it becomes more flexible – although, in either case, the overall mass of the gas remains unchanged and suitably low. Hmmm…

An inflatable 100 kilometer high, 300 kilometer long space pier, built to launch spacecraft horizontally. Humans might survive the G forces required to achieve orbit - which they certainly wouldn't do if the same trajectory was attempted from sea-level. Credit: Josh Hall, autogeny.org/tower/tower.html

If this all seems a bit implausible, there’s always the proposed 100 kilometer high space pier that would enable horizontal space launch without rocketry – perhaps via a giant rail gun, or some other similarly theoretical device that works just fine on paper.

Further reading: Krinker, M. (2010) Review of new concepts, ideas and innovations in space towers. (Have to say this review reads like a cut and paste job from a number of not-very-well-translated-from-Russian articles – but the diagrams are, if not plausible, at least comprehensible).

Steve Nerlich

Steve Nerlich is a very amateur Australian astronomer, publisher of the Cheap Astronomy website and the weekly Cheap Astronomy Podcasts and one of the team of volunteer explainers at Canberra Deep Space Communications Complex - part of NASA's Deep Space Network.

Recent Posts

Plastic Waste on our Beaches Now Visible from Space, Says New Study

According to the United Nations, the world produces about 430 million metric tons (267 U.S.…

17 hours ago

Future Space Telescopes Could be Made From Thin Membranes, Unrolled in Space to Enormous Size

As we saw with JWST, it's difficult and expensive to launch large telescope apertures, relying…

1 day ago

Voyager 1 is Forced to Rely on its Low Power Radio

Voyager 1 was launched waaaaaay back in 1977. I would have been 4 years old…

2 days ago

Webb Confirms a Longstanding Galaxy Model

The spectra of distant galaxies shows that dying sun-like stars, not supernovae, enrich galaxies the…

2 days ago

The Aftermath of a Neutron Star Collision Resembles the Conditions in the Early Universe

Neutron stars are extraordinarily dense objects, the densest in the Universe. They pack a lot…

2 days ago

New View of Venus Reveals Previously Hidden Impact Craters

Think of the Moon and most people will imagine a barren world pockmarked with craters.…

2 days ago